"Maxwell's equations had proved themselves incapable of accounting for dispersion. It appeared necessary to conceive of some structure for dielectrics which would act selectively, imposing different degrees of retardation on light waves of different frequencies. Lorentz achieved this result by assuming that electricity was atomic and that matter was constituted by more or less complicated groupings of these electric atoms or electrons. Phenomena were accounted for by taking into consideration the frictional resistances that would interfere with rapid vibrations of the electrons. When these frictional resistances were weak, oscillatory disturbances, such as rays of light, could be propogated through the dielectric, which was then termed transparent (glass). When these frictional forces were considerable, the light ray was unable to set the electrons into vibration; its energy was consumed in the attempt, and as a result it could not proceed; the dielectric was then opaque (ebonite, sulphur). In the case of conductors such as metals, the electrons were assumed to be very loosely held to their atoms so that the slightest difference of potential would tear them away and cause them to rush in the same direction, thereby producing an electric current. It was precisely because electrons in conductors were not tied down to fixed positions by elastic forces that they were incapable of vibrating; and so conductors were necessarily opaque to electromagnetic vibrations or to light. Conversely, it was because the electrons were all tied down to fixed positions in the dielectrics, that they could not rush along in one direction. As a result dielectrics were opaque to currents, and hence were non-conductors. According to these views of Lorentz, an electric current passing through matter was nothing but a rush of electrons."