"The last four layers of mesh were stapled to the hull mold. They were laid in the same way as the first layers. The mesh was fastened... as smoothly and as tightly as possible. It was clipped onto the horizontal rods with 3/4-inch (19 mm) hog rings. ...One-half inch (12.7 mm) hog ring staples which do a neater job could not be located ...All edges of the mesh were stapled down tightly so that no stray ends of mesh would penetrate later through the fresh mortar and thus interfere with the plasterers' work... Mesh over the chain link scuppers was clipped away and the ends fastened down neatly."